RX-8 Forum
Author Message

RotaryInsider > RX-8 Chat > FAQ

FAQ: My RX-8 shakes at idle. What's going on?

Jason
Posted: Sun Nov 05, 2006 12:31 am
View Single PostView Single Post
Reply with quote
Site Admin Joined: 30 Oct 2006 Posts: 184 Location: North America
Your RX-8 should not shake or vibrate at idle. However, you will feel vibrations in the shifter (manual transmissions only) because the shifter is mounted directly on the transmission.

Possible reasons for vibrations at idle:

Broken engine mounts:

The right hand engine mount is prone to failure due to heat from the engine. There is a TSB for this issue, which will replace the failed mount with one that has a heat shield:

Quote:
APPLICABLE MODEL(S)/VINS
2004-2005 RX-8 vehicles with VINs lower than JM1FE******154999 (produced before May 6, 2005)

DESCRIPTION

Some vehicles may experience the following symptoms.

- On manual transmission vehicles, when decelerating in 3rd gear with engine speed less than 3,000 RPM at approximately 30 MPH (50km/h), then quickly depressing the accelerator pedal again, a hesitation may occur. This symptom can only be observed in this engine speed and vehicle speed range.

- On automatic transmission vehicles, when at a stop in D range, excessive engine/body vibration may occur. This body vibration does not occur in P or N range. Depending on the driving condition or engine condition, the RH side engine mount rubber may deform. As a result, the RH side engine mount can crack. As a mass production change, the material of the engine mount
rubber has been changed. To provide durability of the replaced RH engine mount, an engine bracket with insulator for RH side has been established together with modified engine mount for the LH side.

Customers having this concern should have their vehicle repaired using the following procedure. Replace the RH engine mount and modified RH engine bracket together with the LH engine mount.

Display posts from previous:  

All times are GMT - 5 Hours
Page 1 of 1
Post new topic